19 Of Our Favorite Hot Glue Hacks
19 of our favorite hot glue hacks is article about Woodworking Tips bookmarked by michael with ID 1326713134 was uploaded on 24-02-2019 and has been viewed 311,478 times.
DIY No-Slip Hangers It's so frustrating when clothes fall off of hangers.Whether it's the material or the cut, some garments just slip off of hangers no matter how careful you are when searching through your closet.
It's a pain to constantly bend over to pick them up, and it's definitely a pain to have to clean them again because they've picked up dust and lint and wrinkles from the floor.This simple hanger hack will keep your clothes in place without having to go out and buy expensive specialty hangers.
Apply a bead of hot glue to the top arms of the hanger and let it dry completely.The rubber-like dried glue will keep your clothes in place—even when you're in a rush to get ready and can't find anything to wear! Planing Warped Boards A jointer is the best tool for flattening twisted, warped boards.
But what if you don't have a jointer or the board is too wide? Set the board on a "sled," a flat piece of 3/4-inch plywood.Then shim the high corner(s) so the board doesn't rock.Also shim high spots in the middle of the board.
Mark the shim locations, remove the board and hot glue the shims into place.Then glue the board to the shims and the plywood with a dab of hot glue.Send that rascal through until it's flat, then pull it free and plane down the other side.
Plus: 34 clever handy hints for your woodworking projects...