Saturday Morning Workshop Contemporary Key Hanger
Saturday morning workshop contemporary key hanger is post about Woodworking Projects bookmarked by leon with ID 13680006027 was uploaded on 01-01-2019 and has been viewed 70,234 times.
Cutting List Project Plans Angle the miter saw for a compound bevel Rotate the miter saw's base to 15-degrees.Tilt the blade to 15-degrees in the same direction as the base.For example, I rotated the base handle to the right and tilted the blade to the right.
Create a zero-clearance miter saw fence Fasten a 1x4 board to a piece of 1/4-in.plywood with glue and 1-in.screws.Attach the assembly to the miter saw fence with 3/4-in.screws.Cut a kerf in the fence.This creates a tool that allows perfect alignment and will keep your parts from being pulled into the blade and destroyed.
Mark and cut the compound bevels Make a mark 1/2-in.from one end of the spacer board.Align the mark with the fence's kerf and make the compound bevel cut.Measure 1/2-in.from the short edge of the board.
Align the mark with the kerf and mark a line on the fence where the offcut piece ends.Make the second cut, flip the board edge-over-edge and line up the end with the mark on the fence.Repeat the process until the all the spacers (B) and key fobs (C) are cut.
Glue the spacers Lay out the spacers and fobs so that the grain lines up like one continuous piece.Spread glue onto the backs of the spacers (B).Making sure that the compound bevels are facing the correct way to hold the fobs in place, clamp the spacers (B) in place with painter's tape, using the fobs (C) as for perfect alignment.
Cut to a finished length Return your miter saw to 90-degrees.Mark a line 1/2-in.from the long corner of the last key fob (C) and cut the assembly to length.Install the eye screws In the narrow ends of the fobs, punch starting points using an awl, and then drill pilot holes for eye screws.
Sand and finish the holder assembly and fobs, then install in the eye screws.Looking for a more rustic key hanger to build? Try this one...