Saturday Morning Workshop How To Build A Wine Box
Saturday morning workshop how to build a wine box is bookmark about Woodworking Projects bookmarked by phillip with ID 11535444366 was uploaded on 15-01-2019 and has been viewed 286,836 times.
What It Takes Time: 1 hour Cost: $20 Skill Level: Beginner Cutting List Project Plans *The dimensions in this article are for a specific wine bottle.Measure your bottle before you start building.Click here for another dado stack project.
Mill parts to size Rip the 1x6 board to 5-in.on the table saw.Cut 45-degree bevels into the board with the miter saw so the larger faces are 5-in and 13-in.Rip and crosscut the 1/4-in.board to the dimensions stated in the cutting list for the top, base (C) and handles (D).
Cut dados and rabbets Cut a 1/4-in.x 3/8-in.groove, 1/4-in.from one edge of the sides (A) and ends (B).Clamp a board to the table saw fence and cut a 1/4-in.rabbet into the other edge of the same parts.
Glue together the assembly Lay the sides (A) and ends (B) rabbet/groove face down and tape the corners together.Flip the assembly over and spread glue to the edges of the bevels and groove.Fold up the sides and ends, slip in the base (C) to the grooves and close the last end.
Tape the final joint together and wipe excess glue with a damp rag Glue the handles to the top Mark two lines 1-1/2 in.from both ends of the top (C).Mark two lines 3/8-in.from both ends of the handles (D).
Spread glue in between the lines on the handles and clamp the handles to the top so that the outer edge is along the top part's lines with painter's tape.Wipe excess glue with a damp rag...