Saw Fence Rubdown Sharpens Knives Quickly
Saw fence rubdown sharpens knives quickly is article about Woodworking How To bookmarked by ian with ID 14218051466 was uploaded on 20-03-2019 and has been viewed 107,796 times.
I know the importance of keeping sharp knives in my jointer, but found honing them a pain.Here's an easy-to-build, shop-made jig that makes the job super simple.In a piece of 2x6 lumber about the same length as the knife, cut a groove to fit the blade, and matching the bevel angle of the knife edge.
Jointer knives typically measure about [fraction "1" "8"]"-thick, so a full-kerf cut should do the trick.(Add a layer of tape to tighten the fit in the groove if necessary.) To use the jig, stick a piece of abrasive (220-320 grit) on your tablesaw's table...