Turn Pipe Clamps Into A Support Stand
Turn pipe clamps into a support stand is article about Safety bookmarked by jason with ID 14264895315 was uploaded on 06-04-2019 and has been viewed 199,218 times.
When my pipe clamps aren't working as clamps, they double as versatile shop stands.To create a broad, stable base, I glue up a stack of 12-in.-dia.disks of 3⁄4-in.-thick MDF and scr*w a 3⁄4-in.pipe fl*ng* to the top.
I then remove the fixed jaw from the pipe and scr*w the end into the flange, with the sliding jaw facing upward.To make the cross arms, I drill a 11⁄8-in.-dia.hole through the middle of a board for the pipe, and a shallow 1-in.
hole next to it for flush-mounting a 1-in.-dia.rare-earth magnet.This powerful magnet grabs the adjustable clamp jaw firmly, keeping the arm level.This setup lets me easily raise, lower, and pivot the cross arm to the optimum height for the job at hand.
I use the stand to support the ends of long boards at my drill press or miter saw.I also use…...