Ask Wwgoa Drilling Into Masonry
Ask wwgoa drilling into masonry is bookmark about Blog bookmarked by ray with ID 1748053689 was uploaded on 26-01-2019 and has been viewed 258,239 times.
Question: I recently hung two good sized wall cabinets in my garage.I used French cleats for each and they were affixed to brick veneer in the garage.I used Tapco hardware, including the supplied masonry bit.
I wore out the bit and both arms, but I hung the cabinets.The next project is six sets of functional exterior board and batten shutters which, guess what, require eight bores per window into the same brick to affix the four pintles.
Looking at four dozen bores, what don't I know about drilling into masonry? Should I use a drill, as I have done on the previous project, or an impact driver? Should I run fast or slow? Should I lubricate the bore? Is blasting required? Submitted by anonymous Answer: Blasting would make things go faster, but the resulting hole might be too big for the fastener you're using.
I think the missing ingredient is a hammer….more specifically a hammer drill.Hammer drills put a forward impact on the bit, as opposed to the rotary impact that comes from an impact driver.When drilling into masonry they make a HUGE difference in speed and ease of drilling.
In fact if you don't use a hammer drill...