Preparing Stiles And Rails For Raised Panel Doors
Preparing stiles and rails for raised panel doors is bookmark about Blog bookmarked by jimmy with ID 12063052224 was uploaded on 17-01-2019 and has been viewed 218,263 times.
'When preparing stiles and rails for raised panel doors, my work is frequently plagued by tear out on the edges.This becomes readily apparent on the long cut, where there is a thin section on the back side of approximately 1/16″ and the edge of the curved section on the face side.
The type of material does not appear to be a factor because it has occurred on Poplar, Red Oak and Ash.The cutters appear to be in good shape and sharp.' Submitted by: Cmur WWGOA Editor Response: Make sure your material is the right thickness relative to your cutters.
When possible, I prefer to make my doors from 13/16″ material instead of 3/4″, so that I can have more meat on this part of the profile.Regarding chip out, you should be making a zero clearance fence on your router table before machining your project pieces.
This will help tremendously.Do this by getting the cutter to the right height, set the fence in the correct front to back position, then, with the bit running, push the infeed face of your router table fence into the spinning bit.
(Of course, don't do this with the fence if it isn't made of a...