Transfer Holes From Template To Project
Transfer holes from template to project is bookmark about Shop Tips bookmarked by nathan with ID 12933667897 was uploaded on 24-03-2019 and has been viewed 115,250 times.
The other day I needed to mount an electrical power str*p to the back of a cabinet.On the back of my power str*p were four scr*w mounting holes.I could have spent a lot of time drawing a complex layout on the rear of the cabinet, but instead here's what I did: I cut an over-sized piece of wax paper and using a black marker, I drew a straight line across the width.
Then I stretched the wax paper over the back of the power str*p aligning the black line with two scr*w holes and using an awl, I punched the four holes in the wax paper.I removed the wax paper, trimmed it smaller leaving just the holes and a bit more, aligned and taped it to the back of my cabinet.
I drilled the holes, removed the template, inserted the screws and mounted the power strip.Done!...