Clamp Rack And Outfeed Support In One
Clamp rack and outfeed support in one is article about Plans And Projects bookmarked by gilbert with ID 13390675658 was uploaded on 04-01-2019 and has been viewed 98,961 times.
This simple clamp rack solves two problems.It holds a boat load of bar clamps, (there are 46 on mine) and it provides support adjacent to the table saw.You can build the whole thing from home center materials.
Casters make it mobile so you can easily move it from bench to saw.Here are the dimensions of the parts in my rack: 1 top: 2″ x 6″ x 48″2 upper and lower rails: 2″ x 6″ x 43″1 middle rail: 2″ x 4″ x 43″2 verticals: 2″ x 4″ x ?2 legs: 2″ x 4″ x 24″2 plywood braces: 1/2″ x 8″ x 12″4 2-1/2″ locking casters14 1/2″ x 12″ gas pipe14 1/2″ pipe caps14 1/2″ floor flanges72 #12 x 1″ sheet metal screws Start by carefully measuring the height of your saw.
From that number deduct the height of the casters, the thickness of the legs, and the thickness of the top.The number you end up with is the length of the verticals.I cut mine 1/8″ less than that.Assemble the rack using glue and # 8 x 3″ wood screws to fasten the verticals to the rails.
Glue and scr*w the legs to the bottom end of the vertical...