Intarsia Project This Is An Enjoyable Intarsia Project That Uses The Trace Method For Pattern Transfer
Intarsia project this is an enjoyable intarsia project that uses the trace method for pattern transfer is bookmark about Magazine bookmarked by robert with ID 13668434371 was uploaded on 28-01-2019 and has been viewed 161,111 times.
Leaping Trout Illustration by James Provost Photo enlarge pattern to 160% Begin by selecting wood for all the project pieces, and then transfer the pattern onto tracing paper.Tracing paper allows you to see the grain direction through the pattern.
Make sure that you include the grain direction and alignment marks on the body pieces.The final dimensions of the trout are approximately 6 ½" x 9 ½".Mark out piece (A) using the tracing paper pattern.
Remember to include the alignment marks, as they will help you fit the pieces of the body together.Cut out piece (A) and then sand the bottom edge to remove any burr.This allows the piece to sit flat and makes it easier to trace edges.
If you have an oscillating spindle sander or a drum sander mounted in a drill press, sand the edges square; this will allow for very tight seams between the pieces.Orient the pattern over piece (B) and slide the transfer paper under the pattern.
Place piece (A) into position and using its edge as a guide, mark piece (B).Any inaccuracy in the first cut can be fixed when you mark the second piece.Cut, sand and fit piece (B) to piece...