Portable Project Take Your Own Chair With You When Attending Outdoor Events This Fold Up Chair Is Easy To Carry And Comfortable To Sit On
Portable project take your own chair with you when attending outdoor events this fold up chair is easy to carry and comfortable to sit on is post about Magazine bookmarked by alexander with ID 13837220601 was uploaded on 09-02-2019 and has been viewed 135,531 times.
Folding Chair Illustration by Len Churchill Cut Out The PiecesLightly round over all the corners and edges with a piece of #180 sandpaper folded and held in your hand.Round one end of each chair support with a sanding block or drum sander mounted in your drill.
Seat SlatsDrill countersunk pilot holes centered and ⅜" in from the ends on six of the pine cross pieces.These cross pieces will be used as seat slats.The countersink is ⅜" diameter and the pilot hole is ⅛".
This is usually done a the same time with a countersink attachment on a drill: position the seat slats on two chair supports so the ends are flush and the spacing is even (fig.1), then drill ⅛" pilot holes ½" deep into the chair supports through the pilot holes you previously drilled.
Apply glue to the mating surfaces and scr*w the seat slats onto the supports with 1 ¼" long screws.Check to make sure the assembly is square and allow it to dry.Seat backFor the seat back (fig.2), drill the pilot holes, in the five remaining pine cross pieces, 1 ⅛" in from the ends.
To glue and scr*w the cross pieces in place for...