Turning Project A Large Salad Bowl Is One Of The Most Sought After Woodturning Bowl Designs Here S How To Turn One That You Can Be Proud Of
Turning project a large salad bowl is one of the most sought after woodturning bowl designs here s how to turn one that you can be proud of is bookmark about Magazine bookmarked by adam with ID 12981299968 was uploaded on 12-01-2019 and has been viewed 37,396 times.
Woodturning Bowl Design: Create the Perfect Salad Bowl Photos by Allan Cusworth INFO: DIFFICULTY - 2/5, LENGTH/TIME - 2/5, COST - 2/5The salad bowl in this project is approximately 8" in diameter by 4" high, however, any size of block can be used.
This salad bowl has some unique design features.First, there's a decorative textured band just below the rim.Second, there's a slight undercut inside the top of the rim to allow the bowl to be picked up more easily and to help direct the salad leaves back into the bowl rather than onto the table.
Preparing the blankThis salad bowl is made from an 8-1/2" diameter by 4-1/2" round disk.The first step is to decide the best grain pattern in the blank.Select and mark the side that will be the top of the bowl.
Put a dimple at the center of the block on both sides.Drill a perpendicular hole in the center of the top suitable for a woodworm-type scr*w mount for your chuck.A drill press is best for this.I drilled a 5/16" × 1"-deep hole to fit the Woodworm scr*w in my Super Nova chuck.
Check your chuck's requirements, as each manufacturer is different.Mount the chuck on the...